The Ready to Use Stain Remover is ready to use right out of the container on any natural stones like Granite, Marble, Quartzite, Slate & Travertine. No mixing required and works great removing of oil/grease stains, as well as many other type of stains. Note that this product is only a stain remover will not fix an etch. If the mark is darker than the stone, it is a stain; however, if it is lighter than the stone, it is an etch.
For proper usage, make sure to remove any surface debris or residue before starting. We recommend you clean the surface well with Easy Oxy Daily Cleaner or a similar cleaner. Then follow the following easy steps:
- Take a picture of the area before starting the process. After removing the Stain Remover, and drying the area, take another picture. Pictures make it much easier to see stains and how they change than it is to see in person.
- Place Stain Remover over the affected area and build up approximately 1/4" high and overlap edges of stain by 1/4"-1/2".
- Place plastic wrap over the stain and press down lightly to retard drying time. If it is a warm or dry climate, seal edges of Place plastic wrap over the stain and press down lightly to retard drying time. If it is a warm or dry climate, seal edges of plastic with masking tape to prevent Stain Remover from drying too quickly.
- The solution will dry into a hard crust. Simply scrape the crust off the counter into a trash can and clean any remaining residue with Easy Oxy Daily Cleaner or a similar cleaner. Allow to dry for a couple hours, or dry with a hair dryer for 15 minutes or so. Inspect the area to see if it has improved. If the stain is completely gone, you are done. If the stain is partially removed, repeat the process until gone.